[Advanced Search]

Bleeder screw for 647530 3 1/2 ton floor jack
My jack will not move up continuously. While pumping it upward, it starts to go up but then drops slightly at each pump. Is there air in it? Where is the bleeder screw located? The O-rings on both the handle lowering relief valve and spring loaded pressure shaft (1 1/16 ' nut) seem OK. Thanks! Rick Ihrie

User Opinions (1 vote)
100% thumbs up 0% thumbs down

How would you rate this answer?
Helpful
Not helpful

Visitor Comments

No visitor comments posted. Post a comment
Post Comment for "Bleeder screw for 647530 3 1/2 ton floor jack "
To post a comment for this article, simply complete the form below. Fields marked with an asterisk are required.
   Your Name:
   Email Address:
* Your Comment:
* Enter the code below:
 

Continue

Knowledge Management Software by Interspire