[Advanced Search]

Ball Joint Press Set Up
I have kit #46, if i understand correctly the installation disc is put over the stem side of the ball joint. Is the concave side to be over the c-clamp or positioned toward the ball joint? Is the installation disc the one with the bigger hole or smaller diameter hole? Please confirm that the removing disc is to be placed on top of the sleeve on the threaded end of the c-clamp correct? Is the process reversed, discs and sleeve to press in the new ball joint.

User Opinions (0 votes)
No users have voted.

How would you rate this answer?
Helpful
Not helpful

Visitor Comments

No visitor comments posted. Post a comment
Post Comment for "Ball Joint Press Set Up"
To post a comment for this article, simply complete the form below. Fields marked with an asterisk are required.
   Your Name:
   Email Address:
* Your Comment:
* Enter the code below:
 

Continue

Knowledge Management Software by Interspire