[Advanced Search]

Snap On power washer

Question:I bought the power washer at Costco several months ago but got to use it a few days ago. In the first use of washing sidewalks, and parts of the house, it ran for approximately 2 hours. Today, I started to continue the project but after a short time, it stopped running. I check the GF switch, the on and off switch to no avail. When I turn the unit and water on, the unit partially runs (the buzzing sound prior to pressure being sent. However, it shuts off after several seconds, and then repeats the same process. I checked the Trouble shooting tips in the manual to no avail. What next.
Hello-Sounds lke your using the unit on a extention cord that may be too long reducing the avaiulable voltage or it's not plugged into a dedicate circuit of at least 20 amp capacity;
\Thanks for askiong,

User Opinions (1 vote)
100% thumbs up 0% thumbs down

How would you rate this answer?
Not helpful

Visitor Comments

No visitor comments posted. Post a comment
Post Comment for "Snap On power washer"
To post a comment for this article, simply complete the form below. Fields marked with an asterisk are required.
   Your Name:
   Email Address:
* Your Comment:
* Enter the code below:


Knowledge Management Software by Interspire