[Advanced Search]

model 830210

replaced head gaskets, now compressor only pumps to 50 psi, plus lots of air blowing out of oil fill cap hole. I do not have a manual, could I have put reed vale plates in wrong to create such back pressure?
Some back pressure is normal.  Try opening the drain valve and running about 5 minutes, then shut down and close the drain valve and restart to see if you build proper pressure.  In event this doesn't change, call 1-800-423-3598 so they can assess the problem.
Thanks for asking,

User Opinions (0 votes)
No users have voted.

How would you rate this answer?
Not helpful

Visitor Comments

No visitor comments posted. Post a comment
Post Comment for "model 830210"
To post a comment for this article, simply complete the form below. Fields marked with an asterisk are required.
   Your Name:
   Email Address:
* Your Comment:
* Enter the code below:


Knowledge Management Software by Interspire