[Advanced Search]

3000 psi Gas Pressure Washer
I bought a factory re-furbished Snapon unit a couple of months ago and used it once about a month ago when it performed normally with engine starting on second pull. I tried to use it for the second time yesterday and engine will not start. With choke on, throttle open and wand trigger pulled to release pressure engine fires and runs for a few seconds and stops. With throttle closed engine fires and runs for about 20 seconds before stopping. If choke is taken off during that time engine immediately stops. Gas tank is full and oil level normal. Air filter is clean and gas is flowing when carburetor float chamber is removed. Any suggestions before sending to repair shop?

User Opinions (1 vote)
100% thumbs up 0% thumbs down

How would you rate this answer?
Helpful
Not helpful

Visitor Comments

No visitor comments posted. Post a comment
Post Comment for "3000 psi Gas Pressure Washer"
To post a comment for this article, simply complete the form below. Fields marked with an asterisk are required.
   Your Name:
   Email Address:
* Your Comment:
* Enter the code below:
 

Continue

Knowledge Management Software by Interspire